LED Spot RGBW Tree Gen. 1

The LED Spot RGBW Tree is a recessed LED spot with warm white and colored light for 24VDC supply. The connection to the Miniserver is via Loxone Tree technology.

Datasheet LED Spot RGBW Tree Gen. 1

Table of Contents

Mounting↑

Switch off the supply voltage before installation.

Connect the power supply (orange/white wire) and Tree communication wires (green/white wire).

Flip the spring clips back and snap the spotlight into the mounting hole. Make sure that no wires are jammed.

Commissioning↑

Then follow the pairing procedure on the Tree Interface.

Tree Communication and Voltage Drop↑

If the current flow on the GND line results in a voltage drop too high, this potential difference also affects the tree communication.
To solve this problem, split consumers of higher power over longer distances to several supply lines, or use a supply line with a higher cross-section, or a power supply close to the consumers.
For existing installations, doubling the cross-section of the GND line is often sufficient to eliminate the potential difference.

Actuators↑

Summary Description Value Range
Smart actuator RGBW Smart actuator ∞

Diagnostic Inputs↑

Summary Description Unit Value Range
Online Status LED Spot RGBW Tree Gen. 1 Indicates whether the device can be reached by the Miniserver. Digital 0/1

Properties↑

Summary Description Default Value
Monitor online status If checked, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. -
Serial number Specifies the serial number of the device. -
Actuator Type Use device with Standard Actuator(s) or Smart Actuator(s) Smart Actuators support dynamic fade times and can only be used with the Lighting Controller. -

Safety Instructions↑

The installation must be carried out by a qualified technician in accordance with all applicable regulations.

Ensure that the device is protected from water.

Documents↑

Datasheet LED Spot RGBW Tree Gen. 1