LED Ceiling Spot RGBW Tree Gen.1¶
- Knowledge Base
- Devices
- LED Ceiling Spot RGBW Tree Gen.1
The Loxone LED Ceiling Spot RGBW Tree combines colored light and warm white light. It is controlled and dimmed directly via the Tree interface.
Datasheet LED Ceiling Spot RGBW Tree Gen. 1
Table of Contents¶
- Mounting
- Commissioning
- Tree Communication and Voltage Drop
- Inputs, Outputs, Properties
- Safety Instructions
- Documents
Mounting↑¶
Switch off the supply voltage before installation.
Mount the base plate to the ceiling. The spot will be held to the base plate by 2 magnets.
Connect the power supply and Tree communication wires.
Then place the lamp on the base plate. Make sure that the magnets are positioned correctly and that no wires are jammed.
The additional safety rope is a security feature and must not be removed!
Commissioning↑¶
Then follow the pairing procedure on the Tree Interface.
Tree Communication and Voltage Drop↑¶
If the current flow on the GND line results in a voltage drop too high, this potential difference also affects the tree communication.
To solve this problem, split consumers of higher power over longer distances to several supply lines, or use a supply line with a higher cross-section, or a power supply close to the consumers.
For existing installations, doubling the cross-section of the GND line is often sufficient to eliminate the potential difference.
Actuators↑¶
| Summary | Description | Value Range |
|---|---|---|
| Smart actuator RGBW | Smart actuator | ∞ |
Diagnostic Inputs↑¶
| Summary | Description | Unit | Value Range |
|---|---|---|---|
| Online Status LED Ceiling Spot RGBW Tree Gen. 1 | Indicates whether the device can be reached by the Miniserver. | Digital | 0/1 |
Properties↑¶
| Summary | Description | Default Value |
|---|---|---|
| Monitor online status | If checked, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - |
| Serial number | Specifies the serial number of the device. | - |
| Actuator Type | Use device with Standard Actuator(s) or Smart Actuator(s) Smart Actuators support dynamic fade times and can only be used with the Lighting Controller. | - |
Safety Instructions↑¶
The installation must be carried out by a qualified technician in accordance with all applicable regulations.
Ensure that the device is protected from water.
Documents↑¶
Datasheet LED Ceiling Spot RGBW Tree Gen. 1