LED Surface Mount Spot WW Tree

The Loxone LED Ceiling Spot WW Tree provides warm white light. It is controlled and dimmed directly via the Tree interface.

Datasheet LED Ceiling Spot WW Tree

Table of Contents

Mounting↑

Switch off the supply voltage before installation.

Mount the base plate to the ceiling. The spot will be held to the base plate by 2 magnets.

Connect the power supply and Tree communication wires.

Then place the lamp on the base plate. Make sure that the magnets are positioned correctly and that no wires are jammed.

The additional safety rope is a security feature and must not be removed!

Commissioning↑

For lights, a commissioning mode is active when the devices are supplied with power and have not yet been paired.
In this mode, the device indicates whether it has been connected correctly and, if the connection is successful, provides lighting until it has been paired.

This function is supported since Loxone Config 14.0.3.28, depending on the device firmware.

Then follow the pairing procedure on the Tree Interface.

Actuators↑

Summary Description Value Range
Smart Actuator WW Smart actuator ∞